Properly prepare the surface area. UberTatts should be
applied to smooth surfaces only. The surface areas must be
clean and dry. Area to be covered should not be excessively
cold. (If necessary apply heat from hand-held, hair dryer or
other safe heat source.)

Attach a strip of masking tape (or painters’ masking tape) to
top edge of the UberTatt.  (fig 1)

Align and attach the masking tape to the car.  (fig 2)

Raise the bottom edge of the graphic so that the entire UberTatt hinges on the masking tape.  (fig 3)

Starting from the hinged edge, begin to peel back the
protective coating from the back of the UberTatt

Using your fingers or other smooth object (such as a rubber
squeegee), firmly press and rub the UberTatt against the
vehicle’s surface as you remove the back coating of the UberTatt. (figs 4 & 5)

Slowly remove the wax coating from the front of the UberTatt. (figs 6 & 7)

It will take 24 hours for the adhesive to fully dry.  Do not
wash your vehicle during this time.

Congratulations!  Your UberTatt is ready for
viewing.

If any small bubbles appear after application, pierce the bubble with a pin and rub with
your fingers on the UberTatt to remove the air.

While not recommended, UberTatts can be peeled from the vehicle and repositioned
within the first 15 minutes of application.  We also do not recommend an entire UberTatt be removed and re-applied to another vehicle.